National Engineers' Week Student Competitions
UAA Campus, Anchorage, AK
Saturday February 26, 2005; 10:00 am - 2:00 pm
Balsa Wood Bridge Competition
Last edited 11/05/04
Click here to get a PDF version of the Bridge
Rules.
This prints much better than the web page.
The FREE Acobat Reader is
required to view this file.
Location: UAA Engineering Building Atrium & Materials Lab
Structural Engineering Competition:
Location: UAA Engineering Building Atrium & Materials Lab
Objective
Design and build a bridge using only balsa wood and glue which will support the greatest weight while meeting the required specifications. The winning bridge will be the one that has the highest strength to weight ratio (i.e., the maximum load held divided by the weight of the bridge).
Specifications
Length: 
The
bridge
must span an opening that is 60cm (+ 0.5cm) wide. Allow for some overlap
onto the test stand. The vertical face of the supports may not be used to
provide support for the bridge (i.e., bridges depending on horizontal support
from the test set up will be disqualified). The overall length of
the bridge cannot exceed 76 cm. Bridges longer than 76 cm will not fit on
the load frame.
Width: A commercial 2x2 (actual dimensions are approximately 1.5"x1.5") must be able to pass through the length of the bridge without obstruction.
Height: No limit except as noted above for width.
Shape: Any shape can be submitted, as long as it meets the length, width, and height requirements. It does not have to look like a bridge.
Mass: Bridges should be at or below 50 grams. Bridges more than 50 grams will be penalized by considered the bridge to weigh 50 grams + (actual weight-50 grams)1.5.
Materials: Wood is to 
be
any commercially available BALSA wood.
Glue is to be any commercially available glue. Hardened glue by itself may not be used as a structural member.
Loading: A standard 2.5" muffler clamp (3/8" diameter, 3.1/8" + 1/8" C-C of legs) with a pair of 5 cm square plates (see images) will be attached at the center of the span at the elevation of the test stand (+ 2.5 cm). The bridge MUST accommodate this loading apparatus, so be sure to include it in your design.
Some information on Balsa wood can be found at: http://www.zimsweb.com/balsa/